HC-10 Chlorinated Kleer-Mor

Contains: sodium chloride, 7647-14-5; sodium sulfate, 7757-82-6; sodium carbonate, 497-19-8; pentasodium triphosphate, 7758-29-4; sodium dodecylbenzenesulfonate, 25155-30-0; troclosene sodium, dihydrate, 51580-86-0.

Directions For Use

Cleaning Pipelines and Milking Units

1. Pre-flush pipelines and milking units with large volume of warm water.

2. Prepare wash solution using 1 ounce of HC-10 Chlorinated Kleer-Mor to 2 gallons of hot water (3.7 g/L). Temperature must not go below 110°F/43°C during the wash cycle.

3. Circulate wash solution through system for 5-10 minutes. Brush-wash all parts not coming in contact with the wash solution. Wear impervious gloves when brush-washing equipment.

4. Rinse the milk line with an acid rinse of less than 3.5 pH for 3 to 4 minutes.

5. Just before milking (approximately 20 to 30 minutes), sanitize by circulating proper ppm solution of a recommended sanitizer for 3 to 4 minutes and drain completely.

Cleaning Bulk Tanks

1. Pre-flush bulk tank with large volume of warm water.

2. Prepare wash solution in volume necessary to properly operate the spray device, using 4 ounces of HC-10 Chlorinated Kleer-Mor per each gallon of hot water (30 g/L). Temperature must not go below 110°F/43°C during the wash cycle.

3. Spray-wash for 8-10 minutes. Disconnect return line and drain. Inspect all milk zone surfaces for cleanliness. Prepare wash solution using 4 ounces (118.3 mL) of a chlorinated manual cleaner and not more than 1 gallon (3.78 L) of hot water. Brush-wash valve, outside of tank and any part of tank not cleaned by spraying system. Wear impervious gloves when brush-washing equipment.

4. Rinse inside and outside of bulk tank with potable water to remove all wash solution. Allow to drain.

5. See steps 4 and 5 above.

*Where local or state regulations are in effect, consult authorities for additional information.

Avoid food contamination during application and storage.

Rinse surfaces thoroughly with potable water after use.

This product is not for use as a sanitizer or disinfectant.

Consult your Ecolab representative for specific use instructions and recommended dispensing equipment.

Warning

Causes severe eye irritation.

Wash skin thoroughly after handling. Wear eye protection/ face protection. Mixing this product with acid or ammonia releases chlorine gas. Wash skin thoroughly after handling. Wear eye protection/face protection.

Mixing this product with acid or ammonia releases chlorine gas.

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

READ SAFETY DATA SHEET (SDS) BEFORE USING THIS PRODUCT

EMERGENCY HEALTH INFORMATION: 1 800 328 0026. If located outside the United States and Canada, call collect 1 651 222 5352 (number is in the US).

This product may be patented: www.ecolab.com/patents

Ecolab, 1 Ecolab Place, St. Paul MN 55102 USA

tel. 1 800 392 3392

Distributed by Ecolab

5105 Tomken Road, Mississauga ON L4W 2X5 Canada

tel: 1 800 465 1914

© 2018 Ecolab USA Inc

All rights reserved

Made in United States

www.ecolab.com

CPN: 1449036.0