Proxy-Clean
This page contains information on Proxy-Clean for veterinary use.The information provided typically includes the following:
- Proxy-Clean Indications
- Warnings and cautions for Proxy-Clean
- Direction and dosage information for Proxy-Clean
Proxy-Clean
This treatment applies to the following species:Drinking Water System Cleaner
FOR INDUSTRIAL USE ONLY
● Proxy-Clean® prevents and removes heavy soils.
Directions For Use
Purpose: To efficiently remove heavy soils from the drinking water system
CLEANING WHEN THE SYSTEM IS NOT IN USE:
1 Gallon
● Determine the capacity of the drinking water system
● Prepare a 1-3% solution, depending on the degree of contamination
● Introduce the solution into the system
● Make sure there is adequate air release
● Remove the cap at the end of the drinking system to check for the fizzing reaction, to determine that Proxy-Clean® has reached every point
● Activate all nipples or cups
● Allow the solution to circulate, if possible
● If circulation is not possible, the system must stand full for a minimum of 12 hours
● After cleaning, thoroughly flush with potable water
● Once again, activate all nipples or cups
CLEANING AN OPERATING SYSTEM (animals present)
Mix Proxy-Clean® with water, to the following stock solution/premix:
Pump setting |
Water quantity |
Proxy-Clean® |
1:128 |
5 gallon |
8 oz. |
If cleaning has to be done when animals are present, start with a dosage of 8 ounces of Proxy-Clean® per 5 gallons of water.
For heavier cleaning, the dosage may be raised until a maximum of 20 ounces of Proxy-Clean® per 5 gallons of water is reached.
15 Gallon
● Prepare a 3% solution of Proxy-Clean®
● Introduce the solution into the system
● Make sure there is adequate air release
● Check for the fizzing reaction at the end of the drinking system to determine that Proxy-Clean® has reached every point in the line
● Activate all drinkers
● The system must stand full for a minimum of 12 hours
● After cleaning, thoroughly flush with potable water
● Once again, activate all drinkers
CLEANING AN OPERATING SYSTEM (animals present)
When injecting with a 1:128 medicator:
Mix Proxy-Clean® with water, to the following stock solution/premix:
Cleaning Level |
Pump setting |
Water quantity |
Proxy-Clean® |
Normal |
1:128 |
5 gallons |
8 oz. |
Heavy |
1:128 |
5 gallons |
20 oz. |
For other injection methods:
Measure concentration using hydrogen peroxide test strips, using Parts Per Million (PPM)
Cleaning Level |
Proxy-Clean® Parts Per Million (PPM) |
Normal |
50 PPM |
Heavy |
125 PPM |
PROXY-CLEAN PRODUCTS, Melissa, TX 75454
PROXY-CLEAN® is a registered trademark
www.proxycleanproducts.com
NET CONTENTS: 1 US GALLON / 3.8 L, 15 US GALLONS
CPN: 2052001.1
2020 McKINNEY STREET, MELISSA, TX, 75454
Telephone: | 573-225-8453 | |
Website: | www.proxycleanproducts.com | |
Email: | info@proxyclean.com |
![]() |
THIS SERVICE AND DATA ARE PROVIDED "AS IS". DVMetrics assumes no liability, and each user assumes full risk, responsibility, and liability, related to its use of the DVMetrics service and data. See the Terms of Use for further details. |
Copyright © 2023 Animalytix LLC. Updated: 2022-11-29