Melt-DownThis page contains information on Melt-Down for veterinary use.
The information provided typically includes the following:
- Melt-Down Indications
- Warnings and cautions for Melt-Down
- Direction and dosage information for Melt-Down
Melt-DownThis treatment applies to the following species:
Concentrated Acid Cleaner-Descaler
Formulated for hatchery mechanical washers, heating coils, and nozzles
Concentrated acid cleaner-descaler.
Formulated for hatchery mechanical washers, heating coils, and nozzles.
Melt-Down effectively removes hardened chick down, chemical residues, and hard water salts from hatchery trays, buggies, rack and box washer interiors, heating coil exteriors, and spray nozzles.
Melt-Down is recommended for use stainless steel, ceramic tile, porcelain, fiberglass, rubber, and plastic surfaces.
Directions For Use
Melt-Down may be applied by recirculating pump, brush, by soaking, or with a plastic pump-up sprayer, using the coarse setting of the sprayer for maximum contact.
Depending on the amount of “build up” to be removed on each washer interior, heating coil array, or nozzle, this procedure may require repeating bimonthly, or until the targeted build-up has been completely eliminated.
Directions For Use
1. Empty the mechanical washer tanks, and thoroughly rinse the machine with potable water.
2. Fill the mechanical washer tanks with just enough water to run the pumps (usually, filling to a water level slightly over the coil array is satisfactory).
3. Carefully add 8 gal. (30.28L) of Melt-Down to each washer tank.
4. Turn the mechanical washer on, and allow it to run for 45 minutes to 1 hour.
5. Empty washer tanks and thoroughly rinse the washer before start up.
NOTE: Make sure, when refilling the washer tanks, there are no additional chemicals being injected into the system during this filling procedure. Always use the recommended PPE when handling Melt-Down, as this product contains a strong acid.
SIGNAL WORD: DANGER
Causes severe skin burns and eye damage
Harmful if inhaled
Do not breathe dust/fume/gas/mist/vapors/spray.
Wash thoroughly after handling.
Use only outdoors or in a well-ventilated area.
Wear protective gloves, protective clothing, respiratory protection, and face/eye protection.
Immediately contact a poison control center or doctor/physician.
If swallowed: Rinse mouth. Do NOT induce vomiting.
If on skin or hair: Take off immediately all contaminated clothing. Rinse skin with water/shower.
Wash contaminated clothing before reuse.
If inhaled: Remove person to fresh air and keep comfortable for breathing.
If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing eyes.
For specific treatment, refer to Section 4 of the product Safety Data Sheet (SDS).
STORAGE AND DISPOSAL
StorageStore locked up.
DisposalDispose of contents/container in accordance with Federal, state, and local regulations.
Manufactured by: Preserve International®, a Neogen® Company, 944 Nandino Blvd., Lexington, KY 40511 U.S.A.
Emergency Phone: 1-800-498-5743 (U.S. & Canada) or 1-651-523-0318 (all other areas)
Product Information (non-emergency) Phone: 1-800-621-8829
1 gal. (3.79 L)
55 gal. (208 L)
944 NANDINO BLVD, LEXINGTON, KY, 40511-1205
|Every effort has been made to ensure the accuracy of the Melt-Down information published above. However, it remains the responsibility of the readers to familiarize themselves with the product information contained on the US product label or package insert.|
Copyright © 2020 Animalytix LLC. Updated: 2020-09-29