Oxy-Gard Sanitizing Pre- and Post-Milking Teat Dip (Canada)

DIN 02132605

For Veterinary Use Only

Active Ingredients

Oxy-Gard Sanitizing Pre- and Post-Milking Teat Dip Indications

Pre-milking teat dip for reducing new udder quarter infections caused by Streptococcus uberis. Post milking teat dip for reducing new udder quarter infections caused by Staphylococcus aureus.

For use in dairy cattle.

Directions For Use

Oxy-Gard can be used a post-dip alone or as a pre-and post dip. Always use fresh, full strength Oxy-Gard. If product in dip cup becomes visibly dirty, discard contents, rinse cup and replenish with undiluted Oxy-Gard. Dip cups should be washed after each milking.

Pre-Milking: Wash and dry teats with a single service towel prior to dipping. Before each cow is milked, forestrip and check for clinical mastitis, then dip the teats as far up as possible. Leave Oxy-Gard teat dip on teats for at least 15-30 seconds. Wipe teat dry using a single service towel before milking.

Post-Milking: Immediately after milking dip teats at least 2/3 to all their length in Oxy-Gard teat dip.

Allow to air dry. DO NOT WIPE.

STORAGE: Avoid freezing. However, freezing will not affect the performance of this product, provided that the frozen contents are thawed completely and agitated thoroughly before use.

Store at or below 30°C.

Do not freeze.

CAUTIONS:

For external use only. Do not turn cows out in freezing weather until the dipped teats are completely dry. If teat irritation occurs, discontinue use until irritation subsides. Consult your veterinarian and milking equipment service personnel if irritation persists.

Warnings

No withdrawal period for meat and withholding time for milk are required when used according to the label. Causes eye irritation. Avoid contact with eyes. Wash thoroughly after handling.

First Aid

Eye Contact: In case of contact, immediately flush eyes with plenty of water. Remove contact lenses and flush again. Get medical attention if irritation persists.

Skin Contact: No known effect after skin contact. Rinse with water for a few minutes.

Inhalation: No special measures required. Treat symptomatically.

Ingestion: Get medical attention if symptoms occur.

KEEP OUT OF REACH OF CHILDREN

READ SAFETY DATA SHEET (SDS) BEFORE USING THIS PRODUCT

EMERGENCY HEALTH INFORMATION: 1 800 328 0026. If located outside the United States and Canada, call collect 1 651 222 5352 (number is in the US).

Manufactured for: Ecolab Co., 5105 Tomken Road, Mississauga ON L4W 2X5 Canada

tel. 1 800 465 1914

By: Ecolab Inc., 370 Wabasha Street N, St Paul MN 55102-1390 USA

tel. 1 800 392 3392

© 2014 Ecolab USA Inc

All rights reserved

CPN: 1257011.8