PF 300 (Canada)

DISINFECTANT AND SANITIZER FOR NON-FOOD CONTACT SURFACE, LIVESTOCK HOUSING FACILITIES AND EQUIPMENT

For Industrial Use Only:

Active Ingredient

For disinfecting effectively against Salmonella cholerasuis, Staphylococcus aureus and Pseudomonas aeruginosa.

For non-food contact, sanitizing effective against Klebsiella pneumoniae and Staphylococcus aureus.

Warning

CORROSIVE

DIN 02248634

USE DIRECTIONS AND DILUTION RATES:

Read entire product label, MSDS, and PF 300 Fact Sheet before use. Keep container closed when not in use. Treated surfaces must be rinsed of residual glutaraldehyde prior to contact without PPE.

Thoroughly saturate all surfaces with PF 300 solution using a foaming applicator by mixing PF 300 with water as follows:

For sanitizing:

Mix 5 mL (1:200) of PF 300 per liter of water to provide 336 ppm Didecyl Dimethyl Ammonium Chloride and 625 ppm Glutaraldehyde.

For Disinfecting:

Mix 10 mL (1:100) of PF 300 per liter of water to provide 672 ppm Didecyl Dimethyl Ammonium Chloride and 1250 ppm Glutaraldehyde.

USE DIRECTIONS:

Use the following procedure for cleaning and disinfecting the housing facilities, equipment and transport vehicle interior.

1. Remove all animals and feed. Then remove all dirt, manure, debris from floor or surface.

2. Pressure wash with water to pre-clean.

3. Apply an alkaline cleaner such as JohnsonDiversey LIFT to clean the facility or surface.

4. Rinse with high pressure water.

5. Apply PF 300 (as directed) to disinfect the cleaned surface by a foaming applicator.

6. Allow the disinfected surface to air for 4 hours before admitting livestock.

DANGER: Corrosive. Harmful if swallowed. Harmful if inhaled. Causes irreversible eye damage. Severe skin, lung and digestive tract irritant. Prolonged or repeated skin contact may cause allergic reactions in some individuals. Causes asthmatic signs and symptoms in sensitive individuals.

PRECAUTION: Do not get product in eyes, on skin, or on clothing. Avoid breathing mist, spray, or vapor. Do not swallow. Wear natural rubber, nitrile or butyl rubber gloves, a disposable chemical resistant full-body suit, rubber boots, and a full-face respirator fitted with a combination cartridge filter comprising a P3SL particle filter and an A2 organic vapor filter or equivalent. Wash thoroughly with soap and water after handling. Remove contaminated clothing and wash before reuse. Keep container closed.

Ventilate enclosed area when using product. Access to treated area should be prohibited without the use of suitable personal protective equipment for a minimum period of 4 hours after application.

FIRST AID: In case of contact, immediately flush with water for 15-30 minutes. Remove contaminated clothing and wash before re-use. IF SWALLOWED: DO NOT induce vomiting. Immediately drink one cupful of water or milk. IF BREATHING IS AFFECTED: Remove to fresh air. GIVE FIRST AID, THEN GET MEDICAL ATTENTION IMMEDIATELY.

CORROSIVE LIQUID, ACIDIC, ORGANIC, N.O.S., (GLUTARALDEHYDE), UN3265

JohnsonDiversey Canada, Inc., Oakville Ontario L6H 6P1 Canada

800 668 7171

Emergency No.: 800 668 7171

CPN: 13160002