DuraPrep Surgical: Package Insert / Prescribing Info
Package insert / product label
Generic name: iodine povacrylex and isopropyl alcohol
Dosage form: topical solution
On This Page
Indications and Usage for DuraPrep Surgical
patient preoperative skin preparation:
- for preparation of the skin prior to surgery
- helps reduce bacteria that potentially can cause skin infection
Warnings
For external use only. Flammable, keep away from fire or flame.
To reduce the risk of fire, PREP CAREFULLY:
- solution contains alcohol and gives off flammable vapors
- do not drape or use ignition source (e.g., cautery, laser) until solution is completely dry (minimum of 3 minutes on hairless skin; up to 1 hour in hair).
- avoid getting solution into hairy areas. Wet hair is flammable. Hair may take up to 1 hour to dry.
- do not allow solution to pool
- remove solution-stained material from prep area
Do not use
- on patients with known allergies to iodine or any other ingredients in this product
- on open wounds, on mucous membranes, or as a general skin cleanser
- in infants less than 2 months old due to the risk of excessive skin irritation and transient hypothyroidism
When using this product
- keep out of eyes, ears, and mouth. May cause serious injury if permitted to enter and remain. If contact occurs, flush with cold water right away and contact a doctor.
- to avoid skin injury, care should be taken when removing drapes, tapes, etc…applied over film
- use with caution in women who are breast-feeding due to the potential for transient hypothyroidism in the nursing newborn
DuraPrep Surgical Dosage and Administration
- at the end of the prep, discard any portion of the solution which is not required to cover the prep area. It is not necessary to use the entire amount available.
Getting Patient Ready for Solution:
- use in well-ventilated area
- do not microwave or heat the solution applicator
- apply to clean, completely dry, residue-free, intact skin
- when hair removal is necessary, use a surgical clipper on the morning of the surgery. If a wet shave is used, thoroughly remove all soap residues.
Activating the Applicator:
- grasp product by wrapping hand and fingers around the labeled portion of the applicator. Place thumb on the lever.
- with sponge face parallel to the floor, snap lever. Allow all fluid to flow into sponge.
When Applying Solution:
- DO NOT SCRUB. Paint a single, uniform application and do not reprep area.
- do not allow solution to pool. Use sponge applicator to absorb excess solution and continue to apply a uniform coating. If solution accidentally gets outside of prep area, remove excess with gauze.
- tuck prep towels as needed under both sides of the neck to absorb excess solution. Remove towels before draping.
- avoid getting solution into hairy areas. Wet hair is flammable. Hair may take up to 1 hour to dry.
- when prepping skin folds, toes, or fingers, use a sterile-gloved hand to hold skin apart until completely dry. Otherwise, skin may adhere to itself.
After Applying Solution:
- to reduce the risk of fire, wait until solution is completely dry (minimum of 3 minutes on hairless skin; up to 1 hour in hair). Solution will turn from a shiny to a dull appearance on skin alerting the user that the solution is completely dry and no longer flammable.
While Waiting for Solution to Completely Dry:
- do not drape or use ignition source (e.g., cautery, laser)
- check for pooled solution. Use sterile gauze to soak up pooled solution. Do not blot because it may remove solution from skin.
- remove solution-stained materials. Replace if necessary.
After Solution is Completely Dry:
- to reduce the risk of fire, begin draping and/or using cautery only after solution is completely dry and all solution-stained materials are removed
- if incise drapes are used, apply directly to dry prep. On completion of surgical procedure, removal of incise drape will remove film.
- apply dressing following standard practices
Other information
- store between 20-25ºC (68-77ºF)
- avoid excessive heat above 40ºC (104ºF)
- solution is not water soluble and may stain. Therefore, avoid contact with reusable items (basins, instruments).
Principle Display Panel – 6 mL Applicator Label
3M
STERILE EO
NDC 17518-011-07
Do Not Reuse
1. SNAP
2. PAINT, DO
NOT SCRUB
DuraPrep TM
Surgical Solution
Iodine Povacrylex (0.7% Available Iodine) and Isopropyl Alcohol (74% w/w)
Patient Preoperative Skin Preparation For head, neck, and small prep areas
Non-sterile Solution Applicator is sterile if package is intact
REF 8635 0.2 fl oz • 6 mL
External Use Only Professional Use Only
Read Drug Facts Information before use.
Made in U.S.A. by 3M Health Care
2510 Conway Ave., St. Paul, MN 55144
1-800-228-3957 © 2017, 3M. All rights reserved.
3M and Duraprep are trademarks of 3M.
Principal Display Panel – 6 mL Insert Label
3M
STERILE EO
NDC 17518-011-07
MAL09032040XR
DuraPrep TM
Surgical Solution
Iodine Povacrylex (0.7% Available Iodine)
and Isopropyl Alcohol (74% w/w)
Patient Preoperative Skin Preparation
Non-sterile Solution
Applicator is sterile if package is intact
For head, neck, and small prep areas
Latex-Free
Not Made With Natural Latex
Do Not Reuse
Single Use
DuraPrep Surgical Solution is a film-forming iodophor complex. Each unit dose
applicator contains 0.2 fl oz (6 mL) of solution which covers an approximate 8
in x 10 in area.
3M recommends all users participate in product in-service training prior to use.
In-servicing is available on video, from your 3M sales representative, or at the
3M website (www.3M.com).
REF 8635 0.2 fl oz • 6 mL
3M
Made in U.S.A. by
3M Health Care
2510 Conway Ave
St. Paul, MN 55144
1-800-228-3957
© 2021, 3M. All rights reserved.
3M and DuraPrep are trademarks of 3M
3M DURAPREP SURGICAL
iodine povacrylex and isopropyl alcohol solution |
||||||||||||||||||||
|
||||||||||||||||||||
|
||||||||||||||||||||
|
||||||||||||||||||||
|
||||||||||||||||||||
|
Labeler - Solventum US OpCo LLC (006173082) |
Establishment | |||
Name | Address | ID/FEI | Business Operations |
---|---|---|---|
3M Company | 054950670 | ANALYSIS(17518-011) , PACK(17518-011) |
Establishment | |||
Name | Address | ID/FEI | Business Operations |
---|---|---|---|
3M Company | 078671244 | MANUFACTURE(17518-011) |
Establishment | |||
Name | Address | ID/FEI | Business Operations |
---|---|---|---|
3M Company | 830016148 | ANALYSIS(17518-011) |