Component T-H with TylanThis page contains information on Component T-H with Tylan for veterinary use.
The information provided typically includes the following:
- Component T-H with Tylan Indications
- Warnings and cautions for Component T-H with Tylan
- Direction and dosage information for Component T-H with Tylan
Component T-H with TylanThis treatment applies to the following species:
(trenbolone and tylosin implant)
Each implant consists of 200 mg trenbolone acetate and 29 mg tylosin tartrate
FOR FEEDLOT HEIFERS
20 dose Cartridge Belt
Use with a Component Implanter
For Use In Animals Only
Each cartridge belt holds 20 doses of Component T-H with Tylan (trenbolone and tylosin implant) Implants for feedlot heifers. Each dose of 11 pellets consists of 10 pellets containing a total of 200 mg of trenbolone acetate plus 1 pellet containing 29 mg tylosin tartrate as a local antibacterial. Component T-H (trenbolone implant) Implants are recommended for use in feedlot heifers for INCREASED RATE OF WEIGHT GAIN AND FEED EFFICIENCY.
INDICATIONS FOR USE: This product is a slow-release anabolic agent containing trenbolone acetate which increases rate of weight gain and improves feed efficiency in growing finishing feedlot heifers. This product is to be used in feedlot heifers only during approximately the last 63 days prior to slaughter. Do not use in veal calves. Effectiveness and animal safety in veal calves have not been established.
DOSAGE: Administer 1 implant per animal according to the following instructions.
GENERAL INSTRUCTIONS: Study the instructions which should be followed carefully at all times, avoiding short cuts. Skin infection can be avoided by properly preparing implant site and implanter. During fly season use fly repellent on implant site. One designated team member should always do the implanting. Cleanliness of hands and instruments is important at all times.
Not to be used in animals intended for subsequent breeding, or in dairy animals. Implant one dose - 11 pellets (entire contents of one cartridge cell) - in the ear subcutaneously. Any other site of implantation is in violation of Federal Law. DO NOT attempt to salvage implantation site for animal feed or human food.
A withdrawal period has not been established for this product in pre-ruminating calves. Do not use in calves to be processed for veal.
RESTRICTED DRUG (CALIFORNIA) - USE ONLY AS DIRECTED - FOR USE IN ANIMALS ONLY - NOT FOR HUMAN USE - KEEP OUT OF REACH OF CHILDREN
Loading The Implanter
Load the implanter following the instructions supplied with each implanter.
Restrain The Animal
Speed of implantation as well as safety of handlers is best achieved by restraining animal in a squeeze chute using head restraint. When implanting horned cattle, better control is obtained with additional use of nose tongs.
Prepare The Implant Site
Scrub the back side of the ear (implant site) with a piece of clean absorbent cotton which has been soaked with topical germicidal solution. Follow manufacturer’s directions on germicide for correct strength and preparation of solution. Avoid getting disinfectant in animal’s eyes.
Where To Implant
The full contents of one cartridge cell should be implanted beneath the skin on the back side of the middle one-third of the ear as illustrated in the drawing. The implant must not be closer to the head than the edge of the auricular cartilage ring farthest from the head. The location for insertion of the needle is a point toward the tip of the ear and at least a needle length away from the intended deposition site. Avoid injuring the large arteries, veins and cartilage of the ear.
Insert The Needle
With one hand firmly grasp the ear. With the other hand insert needle point through the skin and ease forward on a lateral plane until the entire length of the needle is under the skin.
Implant The Pellets
After inserting the needle fully in the correct position, squeeze the trigger fully as the needle is withdrawn from the ear. This properly deposits the implant in the needle track. This procedure should prevent breakage or crushing of pellets if otherwise forced into contact with tough fibrous-tissue underlying the skin. The length and total contact area of a single dose are designed to permit absorption of the hormones after implantation to stimulate good weight gain. Broken or crushed pellets may interfere with rates of gain.
Clean The Needle
Clean the implanter needle with alcohol or a properly diluted germicidal solution prior to implanting the next animal.
Store in a refrigerator 2° to 8°C (36° to 46°F) and protect from sunlight.
Use before the expiration date printed on foil pouch. Discard open foil pouches.
ANADA 200-224, Approved by FDA
Manufactured by a non-sterilizing process.
Component T-H with Tylan (trenbolone and tylosin implant) is covered by U.S. Patent No. 5,874,098
Elanco, Component, Tylan and the diagonal bar are trademarks owned or licensed by Eli Lilly and Company, its subsidiaries or affiliates.
Distributed by Elanco Animal Health, a Division of Eli Lilly and Company, Indianapolis, IN 46285, USA
To report adverse events, access medical information, or to obtain additional product information, call 1-800-428-4441
NAC No.: 1031074.0
A Division of Eli Lilly & Co.
2500 INNOVATION WAY, GREENFIELD, IN, 46140
|Small Animal Product Customer Service:||888-545-5973|
|Every effort has been made to ensure the accuracy of the Component T-H with Tylan information published above. However, it remains the responsibility of the readers to familiarize themselves with the product information contained on the US product label or package insert.|
Copyright © 2018 North American Compendiums. Updated: 2018-04-26