Artec

Ultra Conditioning Teat Dip

● An aid in reducing the spread of organisms which may cause mastitis

● Contains an emollient system (glycerin, lanolin and propylene glycol) 78%

CAUTION!

KEEP OUT OF REACH OF CHILDREN

FOR INDUSTRIAL USE ONLY

NOT FOR HUMAN USE.

Directions For Use

IMPORTANT: Do not mix Artec with water, any other teat dips, or other products unless specified in the product use instructions. If transferred from this container to any other, make sure that the other container is thoroughly pre-cleaned and bears the proper container labeling for Artec.

If product in dip cup becomes visibly dirty, discard contents and replenish with undiluted product. Do not reuse or return any unused product to the original container.

Before Milking: Wash teats thoroughly just prior to next milking with appropriate udder wash solution or pre-milking teat dip to avoid contamination of milk. Teats should then be dried with single-service towels. Use proper procedures for udder washing or pre-dipping.

Pre-Milk Dipping: Fill teat dip cup with pre-milking teat dip. Do not dilute. Before each cow is milked, dip each teat full-length into the teat dip cup. Wipe teats dry after dipping using single-service towels to avoid contamination of milk.

Post-Milk Dipping: Immediately after each milking, dip each teat full-length into the teat dip cup containing the product. Allow to air dry. Do not wipe. Always use fresh, full strength Artec. Do not turn cows out in freezing weather until Artec is completely dry.

Expanded Usage: When freshening cows, begin dipping teats twice daily for about 10 days before calving.

PRECAUTION: Artec is not intended to cure or help the healing of chapped or irritated teats. As with any germicide, irritation or sensitization may occur in sensitive animals. In case of teat irritation or chapping, have the condition examined and, if necessary, treated by a veterinarian.

Consult your Ecolab representative for specific use instructions and recommended dispensing equipment.

CAUTION!

MAY CAUSE EYE AND SKIN IRRITATION. Use suitable protective equipment. Wash thoroughly after handling.

FIRST AID

Eye Contact: In case of contact, immediately flush eyes with plenty of water. Remove contact lenses and flush again. Get medical attention if irritation persists.

Skin Contact: In case of contact, immediately flush skin with plenty of water. Remove contaminated clothing and shoes. Get medical attention if irritation persists. Wash clothing before reuse. Clean shoes thoroughly before reuse.

Inhalation: No special measures required. Treat symptomatically.

Ingestion: Get medical attention if symptoms occur.

READ MATERIAL SAFETY DATA SHEET (MSDS) BEFORE USING THIS PRODUCT

EMERGENCY HEALTH INFORMATION: 1 800 328 0026. If located outside the United States and Canada, call collect 1 651 222 5352 (number is in the US).

Ecolab, 370 Wabasha Street N, St Paul MN 55102-1390 USA

tel. 1 800 392 3392

© 2011 Ecolab USA

Made in United States

www.ecolab.com

CPN: 1449016.2