Nasal Allergy by HyVee Inc

Triamcinolone acetonide (glucocorticoid) 55 mcg

Nasal allergy symptom reliever

temporarily relieves these symptoms of hay fever or other upper respiratory allergies:

•

nasal congestion

•

runny nose

•

sneezing

•

itchy nose

•

in children under 2 years of age

•

if you have ever had an allergic reaction to any of the ingredients

•

have had recent nose ulcers or nose surgery

•

have had a nose injury that has not healed

•

are using a steroid medicine for asthma, allergies or skin rash

•

have an eye infection

•

have or had glaucoma or cataracts

•

the growth rate of some children may be slower

•

some symptoms may get better on the first day of treatment. It may take up to one week of daily use to feel the most symptom relief.

•

do not share this bottle with anyone else as this may spread germs

•

remember to tell your doctor about all the medicines you take, including this one

•

you have, or come into contact with someone who has, chickenpox, measles or tuberculosis

•

you have or develop symptoms of an infection such as a persistent fever

•

you have any change in vision

•

you have severe or frequent nosebleeds

ask a health professional before use.

In case of overdose, get medical help or contact a Poison Control Center right away. (1-800-222-1222)

Read insert (inside package) on how to:

•

get a new bottle ready (primed) before first use

•

prime bottle again if not used for more than 2 weeks

•

use the spray

•

clean the spray nozzle

 

● do not use more than directed

 

● if you forget a dose, do not double the next dose

 

● do not spray into eyes or mouth

 

● if allergy symptoms do not improve after one week, stop using and talk to a doctor

 

● do not use for the common cold

 

● shake well before each use

•

do not use if printed bottle wrap is torn or opened {Carton Only}

•

do not use if sealed package is torn or opened {Stretch Card Only}

•

keep package and insert. They contain important information.

•

store between 20o-25oC (68o-77oF)

benzalkonium chloride, carboxymethylcellulose sodium, dextrose anhydrous, edetate disodium dihydrate, hydrochloric acid or sodium hydroxide (for pH adjustment), microcrystalline cellulose, polysorbate 80, purified water

1-800-719-9260

Triamcinolone Acetonide (Glucocorticoid)

Multi-Symptom

55 mcg Per Spray / Nasal Allergy Symptom Reliever

Nasal Allergy Spray

IMPORTANT INFORMATION

•

Read both sides of this insert for complete instructions on how to get a bottle ready (primed), how to use the spray bottle and how to clean the spray nozzle.

•

Keep this insert as it contains important information.

STEPS TO GET A NEW BOTTLE READY FOR USE (PRIMED)

1. Before first use, a new bottle must be primed.

a.

Remove cap and safety clip (Figure A).

b.

Shake bottle.

c.

Press and release spray nozzle until a fine mist is produced (as shown in Figure B). This may take several times.

 

Take care not to spray in face.

PRIME BOTTLE AGAIN IF NOT USED FOR MORE THAN 2 WEEKS

•

Repeat steps for priming a bottle (see above).

USE INSTRUCTIONS

1.

Blow nose gently to clear nostrils.

2.

Remove cap and safety clip, then shake bottle.

3.

Hold bottle with thumb under bottle and spray nozzle between fingers (as shown in Figure B).

4.

Press against the outside of your nose with your finger to close off one nostril (as shown in Figure C).

5.

Place the tip of the spray nozzle into the other nostril. The spray nozzle should not reach far into the nose. Aim nozzle toward back of nose (as shown in Figure C).

DO NOT spray toward nasal septum (the wall between the 2 nostrils) (as shown in Figure D).

6. While sniffing gently, spray into nostril.

IMPORTANT: For complete dosing instructions, See “Directions for use” on next side.

7. Repeat steps “4” through “6” for the other nostril.

8. After using the nasal spray, wipe nozzle with a tissue, replace safety clip, and replace cap by pressing it down over the spray nozzle.

NOTE: Avoid blowing nose for 15 minutes after use.

If nozzle does not spray properly, see cleaning instructions on next side.

(continued on side 2)

SIDE 1

IF PUMP DOES NOT SPRAY PROPERLY, THE NOZZLE MAY BE BLOCKED

1.

Never try to unblock nozzle with a pin or any other object (as shown in Figure E).

2.

Clean the nozzle as shown below.

CLEANING INSTRUCTIONS

1.

Gently pull spray nozzle away from bottle (as shown in Figure F).

2.

Rinse SPRAY NOZZLE ONLY under warm water (as shown in Figure G).

3.

Shake or tap to remove excess water.

4.

Re-attach spray nozzle to bottle.

5.

Press and release spray nozzle until a fine spray is produced, taking care not to spray in face.

Triamcinolone Acetonide (Glucocorticoid) pump is now ready to use.

Where can I get more information? 1-800-719-9260

Store between 20°-25°C (68°-77°F)

Made in Israel

Distributed By

Perrigo®

Allegan, MI 49010

SIDE 2

: 44300 00 J2

COMPARE TO the Active Ingredient of Nasacort® Allergy 24 HR

Original Prescription Strength

Multi-Symptom

Nasal Allergy Spray

Triamcinolone Acetonide (Glucocorticoid)

55 mcg per spray

Nasal Allergy Symptom Reliever

24 Hour Relief of:

Nasal Congestion

Sneezing

Runny Nose

Itchy Nose

120 SPRAYS

0.57 FL OZ (16.9 mL)