Skip to Content

Elspar Dosage

Generic name: ASPARAGINASE 10000[iU]
Dosage form: injection, powder, lyophilized, for solution

The information at Drugs.com is not a substitute for medical advice. Always consult your doctor or pharmacist.

Recommended Dose

The recommended dose of Elspar is 6,000 International Units/m2 intramuscularly (IM) or intravenously (IV) three times a week.

Instructions for Administration

When Elspar is administered IM, the volume at a single injection site should be limited to 2 mL. If a volume greater than 2 mL is to be administered, two injection sites should be used. Discard unused portion.

When administered IV, give Elspar over a period of not less than thirty minutes through the side arm of an infusion of Sodium Chloride Injection or Dextrose Injection 5% (D5W). Discard unused portion.

Preparation and Handling Precautions

For IM administration, reconstitute Elspar by adding 2 mL Sodium Chloride Injection to the 10,000 unit vial. Withdraw volume of reconstituted Elspar containing calculated dose into sterile syringe. The reconstituted solution contains 5,000 international units (IU)/mL.

For IV administration, reconstitute Elspar by adding 5 mL Sterile Water for Injection or Sodium Chloride Injection to the 10,000 unit vial. Withdraw volume of reconstituted Elspar containing calculated dose into sterile syringe. The reconstituted solution contains 2,000 IU/mL.

Use reconstituted Elspar within eight hours.

Parenteral drug products should be inspected visually for particulate matter, cloudiness or discoloration prior to administration, whenever solution and container permit. If any of these are present, discard the solution. However, occasionally, a very small number of gelatinous fiber-like particles may develop on standing. Filtration through a 5.0 micron filter during administration will remove the particles with no resultant loss in potency.

More about Elspar (asparaginase escherichia coli)

Consumer resources

Professional resources

Related treatment guides

Hide