Wescodyne* (Canada)

This page contains information on Wescodyne* for veterinary use.
The information provided typically includes the following:
  • Wescodyne* Indications
  • Warnings and cautions for Wescodyne*
  • Direction and dosage information for Wescodyne*

Wescodyne*

This treatment applies to the following species:
Manufacturer: West Penetone

“tamed iodine*”

LIQUID GENERAL PURPOSE GERMICIDE

GUARANTEE:

Polyethoxypolypropoxypolyethoxyethanol-iodine complex

9.10%

Nonylphenoxypoly (ethyleneoxy) ethanol-iodine complex

8.74%

(Provides 1.6% min. titratable iodine).

REGISTRATION NO. 11755 PEST CONTROL PRODUCTS ACT

DIN 02012359

READ THE LABEL BEFORE USING

CAUTION - CORROSIVE

GERMICIDAL ACTION: In use-dilution WESCODYNE kills the Herpes Simplex virus, most bacteria, molds and fungi which may be found on inanimate surfaces.

DIRECTIONS FOR USE:

GENERAL: Ensure that the surface has been properly cleaned with a suitable detergent prior to disinfecting. For general disinfecting use 180 mL of WESCODYNE to 20 litres of water. Allow surface to remain wet for 10 minutes, then remove excess liquid. Prepare a fresh solution for each use. WESCODYNE contains several synthetic detergents. No soaps or other cleaners should be added.

SANITIZING: Use 60 mL of WESCODYNE to 20 litres of water for sanitizing. WESCODYNE is not adversely affected by common water hardness or low temperatures. Ensure that the surface has been properly cleaned with a suitable detergent prior to sanitizing.

FOOD PROCESSING EQUIPMENT: Wash with a solution of 90 mL of WESCODYNE to 20 litres of water. Rinse thoroughly with potable water.

MEAT PACKAGING PLANTS: For the control of bacteria, molds, and fungi on walls, ceilings and refrigerators, wash with 90 mL of WESCODYNE to 20 litres of water. Rinse thoroughly with potable water. All of the above surfaces and equipment should be rinsed with a final sanitizing solution of 30 mL of WESCODYNE (25 ppm) to 20 litres of water.

PRECAUTIONS: Avoid contact with eyes. Keep out of reach of children. Avoid contamination of food.

TOXICOLOGICAL INFORMATION:

In case of accidental contact, flush eyes with plenty of water. If irritation persists, consult a physician. If accidentally swallowed, administer milk or egg whites and large quantities of water. Do not induce vomiting. Contact a physician or poison control center immediately. Take a container, label or product name and Pest Control Product Registration Number with you when seeking medical attention.

NOTICE TO USER: This control product is to be used only in accordance with the directions on the label. It is an offense under the Pest Control Products Act to use a control product under unsafe conditions.

DISPOSAL:

1. Triple or pressure rinse the empty container. Add the rinsings to the treatment site.

2. Follow provincial instructions for any required additional cleaning of the container prior to its disposal.

3. Make the empty container unsuitable for further use.

4. Dispose of the container in accordance with provincial requirements.

5. For information on the disposal of unused, unwanted product and the cleanup of spills, contact the Provincial Regulatory Agency of the Manufacturer.

MADE IN CANADA

MANUFACTURED BY: WEST PENETONE INC., 10,900 RUE SÉCANT ST., VILLE D’ANJOU, QUÉBEC H1J 1S5

Branches in principal cities

NET CONTENTS:

 

4 Litres

7510

NAC No.: 13420050

WEST PENETONE INC.
10,900 SECANT STREET, MONTREAL (ANJOU), QC, H1J 1S5
Telephone:   514-355-4660
Toll-Free:   800-361-8927
Website:   www.westpenetone.com
Every effort has been made to ensure the accuracy of the Wescodyne* information published above. However, it remains the responsibility of the readers to familiarize themselves with the product information contained on the Canadian product label or package insert.

Copyright © 2014 North American Compendiums. Updated: 2014-07-28

(web5)