Ferrodex 200

Manufacturer: AgriLabs

(iron Dextran Injection)

200 Mg/ml

Hematinic

ANADA 200-256, Approved by FDA

Description

FERRODEX^® 200 (Iron Dextran Injection) is a sterile solution containing ferric hydroxide in complex with a low molecular weight dextran fraction equivalent to 200 mg elemental iron per mL with 0.5% phenol as a preservative.

Actions

FERRODEX^® 200 (Iron Dextran Injection) is easy and economical to use. Injection into the ham is rapid, safe, effective, quickly absorbed by the blood and goes to work immediately. With FERRODEX^® 200 (Iron Dextran Injection), the right dosage can be given to every animal with assurance that it will be utilized. Iron deficiency anemia occurs commonly in the suckling pig, often within the first few days following birth. As body size and blood volume increase rapidly from the first few days following birth, hemoglobin levels in the blood fall due to diminishing iron reserves which cannot be replaced adequately from iron in the sow’s milk. This natural deficiency lowers the resistance of the pig and scours, pneumonia or other infections may develop and lead to death of the animal. Pigs not hampered by iron deficiency anemia are more likely to experience normal growth and to maintain their normal level of resistance to disease. Adequate iron is necessary for normal, healthy, vigorous growth.

Ferrodex 200 Indications

FERRODEX^® 200 (Iron Dextran Injection) is intended for the prevention or treatment of anemia in baby pigs due to iron deficiency.

Notice

Organic iron preparation injected intramuscularly into pigs beyond 4 weeks of age may cause staining of the ham muscle.

Ferrodex 200 Dosage And Administration

For the prevention of anemia due to iron deficiency, administer an intramuscular injection of 200 milligrams of elemental iron (1 mL) at 1 to 3 days of age. For the treatment of anemia due to iron deficiency, administer an intramuscular injection of 200 milligrams of elemental iron (1 mL) at the first signs of anemia.

Directions For Use

Disinfect rubber stopper of vial as well as site of injection. Use small needle (20 gauge 5/8 inch) that has been sterilized (boiled in water for 20 minutes). Injection should be intramuscular into the back of the ham. Place tension on the skin over the rear of the ham and inject to a depth of 1/2” or slightly more.