Component E-S Implants with Tylan (Canada)This page contains information on Component E-S Implants with Tylan for veterinary use.
The information provided typically includes the following:
- Component E-S Implants with Tylan Indications
- Warnings and cautions for Component E-S Implants with Tylan
- Direction and dosage information for Component E-S Implants with Tylan
Component E-S Implants with TylanThis treatment applies to the following species:
FOR VETERINARY USE ONLY
20-DOSE CARTRIDGE BELT
For use with a Component Implanter
Component E-S Implants with Tylan Indications
For increased rate of weight gain and improved feed efficiency in steers weighing 185 to 450 kg. Tylan is included as a local antibacterial for reducing the incidence of abscess formation at the implant site.
Each CARTRIDGE BELT holds 20 doses of COMPONENT E-S Implants with Tylan. Each dose of 9 pellets consists of 8 pellets containing a total of 200 mg of progesterone USP and 20 mg estradiol benzoate plus 1 pellet containing 29 mg tylosin tartrate as a local antibacterial for reducing the incidence of abscess formation at the implant site. COMPONENT E-S Implants with Tylan provide complementary amounts of these hormones to help speed up the steer’s weight gaining mechanism, and help improve feed efficiency. COMPONENT E-S Implants with Tylan are recommended for use in steers weighing 185 to 450 kg.
COMPONENT E-S Implants with Tylan are not recommended for use in staggy (bulling) or extremely restless animals. Not intended for use in breeding animals. It is good husbandry to isolate bullers.
WarningDo not use in calves to be processed for veal. Implant COMPONENT E-S Implants with Tylan in the ear only; any other location may result in condemnation of the carcass. Do not attempt to salvage the implanted ear for human or animal food. Keep out of reach of children.
Component E-S Implants with Tylan Caution
Bulling, rectal prolapse, ventral edema and elevated tailheads have been reported in animals implanted with progesterone and estradiol benzoate implants.
StorageDo not freeze. Store at 10° to 27°C and protect from direct sunlight.
Study the instructions which should be followed carefully at all times. Avoid short cuts. Skin infection can be avoided by properly preparing implant site. During fly season use fly repellent on implant site. One designated team member should always do the implanting. Cleanliness of hands and instruments is important at all times.
Loading the Implanter:
Load the implanter following the instructions supplied with each implanter.
Restrain The Animal
Speed of implantation as well as safety of handlers is best achieved by restraining animal in a squeeze chute using head restraint.
Prepare The Implant Site
Scrub the back side of the ear (implant site) with a piece of clean absorbent cotton which has been soaked with topical germicidal solution. Follow manufacturer’s directions on germicide for correct preparation and strength of solution. Avoid getting into animal’s eyes.
Where To Implant
The full contents of the cartridge (all 9 pellets) should be implanted beneath the skin on the back side of the middle one-third of the ear as illustrated in the drawing. The implant must not be closer to the head than the edge of auricular cartilage ring farthest from the head. The location for insertion of the needle is a point toward the tip of the ear and at least a needle length away from the intended deposition site. Avoid injuring the large arteries, veins and cartilage of the ear.
Insert The Needle
With one hand firmly grasp the ear. With other hand insert needle point through the skin and ease forward on a lateral plane until the entire length of the needle is under the skin.
Implant The Pellets
After inserting the needle fully in the correct implant position, squeeze the trigger fully as the needle is withdrawn from the ear. This properly deposits the implant in the needle track. This procedure should prevent breakage or crushing of pellets if otherwise forced into contact with tough fibrous-tissue underlying the skin. The length and total contact area of the single dose are designed to permit absorption of the hormones after implantation to stimulate good weight gain. Broken or crushed pellets may interfere with rates of gain and may lead to undesirable side effects such as noted in the CAUTION.
Clean The Needle
Disinfect the implanter needle with a germicidal solution prior to implanting the next animal.
Contains: 100 implants; five (5) cartridge belts of 20 implants each, sealed in sanitary foil pouches.
The weight increase is dependent on the quality of the animal and the feed. Maximum growth will be attained with good quality stock that is free from parasitism and disease.
U.S. Patent No. 5,874,098
Elanco, Component, Tylan and the diagonal bar are trademarks owned or licensed by Eli Lilly and Company, its subsidiaries or affiliates.
Manufactured by Elanco, Division Eli Lilly Canada, Inc., 150 Research Lane, Suite 120, Guelph, ON, Canada, N1G 4T2
NAC No.: 11840192
RESEARCH PARK CENTRE, 150 RESEARCH LANE, SUITE 120, GUELPH, ON, N1G 4T2
|Elanco Canada Limited Customer Service Telephone:||800-387-6325|
|Elanco Canada Limited Customer Service Fax:||800-827-5782|
|Every effort has been made to ensure the accuracy of the Component E-S Implants with Tylan information published above. However, it remains the responsibility of the readers to familiarize themselves with the product information contained on the Canadian product label or package insert.|
Copyright © 2015 North American Compendiums. Updated: 2015-07-09